The short version of Selank fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2025-09-04. Anything still debated is marked as such rather than presented as settled.
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro. It was designed at the Institute of Molecular Genetics of the Russian Academy of Sciences as a structural analogue of tuftsin, a naturally occurring tetrapeptide fragment of the immunoglobulin heavy chain. The added Pro-Gly-Pro tail was intended to slow enzymatic degradation and extend biological activity. In Russia it is registered as an anxiolytic nasal preparation, while regulators elsewhere have not approved it for clinical use.
Proposed mechanisms centre on modulation of the GABAergic system, with reports of altered expression of genes related to GABA-A receptor subunits and changed monoamine turnover. Some studies describe inhibition of enkephalinase, the enzyme that degrades endogenous enkephalins, which may prolong opioid peptide signalling. Effects on brain-derived neurotrophic factor and on cytokine expression have also been reported. These findings come largely from animal models and small human studies, and the precise primary target remains unresolved.
Characterization of Selank in a laboratory setting relies on standard peptide methods. Reverse-phase high-performance liquid chromatography separates the target from related impurities and provides a purity figure, commonly reported as 95 percent or higher. Mass spectrometry, typically electrospray ionization or matrix-assisted laser desorption, confirms the molecular mass and helps detect truncation or modification. Amino acid analysis can verify composition when a sequence-level check is needed. These techniques together establish identity and purity for a given lot.
Lyophilized Selank, the dry powder form, is generally stored frozen at minus 20 degrees Celsius or colder for long-term keeping. The solid is hygroscopic and should stay sealed, dry, and protected from light. Once dissolved, the peptide is less stable and is usually held refrigerated at 2 to 8 degrees Celsius for short periods. Repeated freezing and thawing is avoided because it can promote aggregation and loss of activity. Buffers and pH choice also affect how long a solution remains usable.
Solubility behavior is a practical concern for handling. Selank dissolves readily in water and in common aqueous buffers, which simplifies preparation of working solutions. The choice of solvent, ionic strength, and pH can influence aggregation over time, particularly at higher concentrations. Aqueous solutions are typically sterile-filtered before use. Because stability depends on several variables, storage and handling notes should be treated as general guidance rather than fixed rules, and specific values are best confirmed against a certificate of analysis for each batch.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C33H57N11O9 | Free peptide form |
| Molecular mass | About 751.9 Da | Calculated average mass |
| Amino acid sequence | Thr-Lys-Pro-Arg-Pro-Gly-Pro | Single-letter form TKPRPGP |
| Structural basis | Tuftsin analogue | Extended version of a natural tetrapeptide |
| Development origin | Russian Academy of Sciences | Work carried out from the 1980s onward |
Published work on this peptide almost always uses intranasal delivery, with drops or a spray applied to the nasal mucosa. Some animal experiments have used subcutaneous or intraperitoneal injection, and a smaller number have compared routes directly. Oral administration is not a focus of the literature, because short peptides of this size are broken down by digestive enzymes and cross intestinal barriers poorly. How much of an intranasal dose reaches the bloodstream intact in humans remains an open question.
Animal studies have examined behaviour in tests of anxiety, memory retention and stress response, and several report changes in neurotrophic or neurotransmitter-related markers. The human evidence base is much smaller, consisting mainly of short trials conducted in Russia with limited reporting in English-language journals. Sample sizes are modest and outcome measures vary between studies, so the findings are best described as preliminary. Independent replication under modern trial standards has not been widely reported.
Identity and purity of selank are established with reversed-phase high-performance liquid chromatography coupled to mass spectrometry. The peptide elutes from C18 columns with acetonitrile gradients in water containing trifluoroacetic acid or formic acid, and detection is usually performed by ultraviolet absorbance near 214 nm. Electrospray ionization in positive mode gives a doubly protonated ion near m/z 377, consistent with a mass of about 752 Da. Amino acid analysis or tandem mass spectrometry of fragment ions confirms the sequence. Because the molecule has no aromatic residues, it lacks a usable 280 nm chromophore, so low-wavelength detection or mass spectrometry is required.
Peptide bonds in selank are susceptible to hydrolysis under strongly acidic or basic conditions, and the terminal proline residues are vulnerable to exopeptidase activity in biological samples. Lyophilized powder stored dry at -20 °C typically remains stable for extended periods, whereas aqueous solutions degrade faster and may lose measurable purity within days to weeks depending on pH, temperature, and microbial load. Repeated freeze-thaw cycles promote aggregation and adsorption to container surfaces. For analytical work, solutions are usually prepared fresh, kept cold, and used within a single working day.
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro, written TKPRPGP in one-letter notation. Its structure consists of the immunomodulatory tetrapeptide tuftsin, Thr-Lys-Pro-Arg, extended at the carboxyl terminus by a Pro-Gly-Pro segment. The molecular formula is commonly given as C33H57N11O9, corresponding to a monoisotopic mass near 751.4 Da and an average molecular mass near 751.9 Da. All seven residues are proteinogenic amino acids, and the molecule carries no modified side chains or non-natural linkages.
The compound was designed at the Institute of Molecular Genetics of the Russian Academy of Sciences during the 1980s and 1990s. The stated design goal was to retain the immunomodulatory and central nervous system activity attributed to tuftsin while improving resistance to enzymatic breakdown. Adding a proline-rich tail to the short parent peptide was a deliberate strategy, because proline residues restrict the conformations available to many peptidases. The same laboratory produced Semax, an ACTH fragment analog, and both compounds were developed in parallel as short, enzymatically stabilized peptides intended for intranasal use.
Laboratory work relies on standard behavioral paradigms. Rodents are tested in the elevated plus maze, open field, and passive avoidance tasks, with outcomes compared against diazepam or vehicle controls. Intranasal dosing is used most often because it bypasses first-pass metabolism, though intraperitoneal and intravenous routes also appear in published protocols. Biochemical endpoints include tissue BDNF concentrations, cytokine levels, and monoamine metabolites. Human data are limited to small Russian trials reporting reduced anxiety scores; most were not prospectively registered, and few employed independent outcome assessment.
Measuring peptide exposure inside the brain is technically difficult. Selank is degraded rapidly in plasma, and assays must separate intact peptide from fragments, which favors targeted mass spectrometry over immunoassays alone. Reported half-lives are short, on the order of minutes, so effects observed hours later are attributed to downstream signaling rather than to the parent compound. Blood-brain barrier permeability is debated and rarely quantified directly. Gaps include absent dose-response characterization, inconsistent reporting of purity, and almost no pharmacokinetic data from human participants.
=== Second Trump administration (2025–present) === In January 2025, President Donald Trump revoked Biden's Executive Order 14110 (Executive Order on Safe, Secure, and Trustworthy Development and Use of Artificial Intelligence) by issuing Executive Order 14148 (Initial Rescissions of Harmful Executive Orders and Actions), reflecting his administration's preference for deregulating AI in support of innovation over safeguarding risks. He then issued Executive Order 14179 (Removing Barriers to American Leadership in Artificial Intelligence), which called for development of a national "AI Action Plan" and aimed to strengthen U.S. leadership in AI. In 2025, Congress passed legislation targeting AI-generated deepfakes, the TAKE IT DOWN Act, which prohibits nonconsensual disclosure of AI-generated "intimate imagery", requiring all platforms to remove such content. Lawmakers also reintroduced the CREATE AI Act to codify the National AI Research Resource (NAIRR), which aimed to expand public access to computing resources, datasets, and AI testing environments. Meanwhile, the Department of Commerce also expanded export controls on AI technology, and NIST published an updated set of guidances on AI cybersecurity risks. In March 2025, OpenAI made a policy proposal for the Trump administration to preempt pending AI-related state laws with federal laws. Meta, Google, IBM and Andreessen Horowitz also pressured the government to adopt national rules that would rein in state laws, especially in California.
== Formats and the submission process == Since detailed proteomics data currently cannot be curated from the existing literature, the source of PRIDE data is solely submissions by academic researchers. PRIDE is a standards-compliant public repository, meaning that its own XML-based data exchange format for submissions, PRIDE XML, was built around the Proteomics Standards Initiative mzData standard for mass spectrometry. Recently, PRIDE has been adapted to work with the modern mzML and mzIdentML standards of the Proteomics Standards Initiative. An additional format, dubbed mzTab, can be used as a simplified way to submit quantitative proteomics data. As there are many types of different mass spectrometry instruments and software formats are currently on the market, wet-lab scientists without a strong bioinformatics background or informatics support were having problems converting their data to PRIDE XML. The development of PRIDE Converter helped to tackle this situation. PRIDE Converter is a tool, written in the Java programming language, that converts 15 different input mass spectrometry data formats into PRIDE XML via a wizard-like graphical user interface. It is freely available and is open source under the permissive Apache License. A new version of PRIDE Converter was released in 2012 as PRIDE Converter 2. This new version constituted a complete rewrite, focused on easy adaptability to different (and evolving) data sources.
Several assumptions were made in the formulation of these equations: First, an individual in the population must be considered as having an equal probability as every other individual of contracting the disease with a rate of
Sources: en.wikipedia.org
Light Source Spectra at the Wayback Machine (archived 2025-05-28) 60 W–100 W Incandescent light bulb spectra, from Cornell University Program of Computer Graphics Slow-motion video of an incandescent lightbulb filament Ribbon machine in operation at Osram-Sylvania in 2016
A material is defined as a substance (most often a solid, but other condensed phases can be included) that is intended to be used for certain applications. There are a myriad of materials around us; they can be found in anything from buildings and cars to spacecraft. The main classes of materials are metals, semiconductors, ceramics and polymers. New and advanced materials that are being developed include nanomaterials, biomaterials, and energy materials to name a few. The basis of materials science is studying the interplay between the structure of materials, the processing methods to make that material, and the resulting material properties. The complex combination of these produce the performance of a material in a specific application. Many features across many length scales impact material performance, from the constituent chemical elements, its microstructure, and macroscopic features from processing. Together with the laws of thermodynamics and kinetics materials scientists aim to understand and improve materials.
Between 60% and 75% also mentioned other factors such as core clerkship grades, perceived commitment to specialty, audition elective/rotation within your department, any failed attempt in USMLE, class ranking/quartile, personal prior knowledge of the applicant, perceived interest in program and passing USMLE Step 2 CS. These factors often come as a surprise to many students in the preclinical years, who often work very hard to get great grades, but do not realize that only 45% of directors cite basic science performance as an important measure. Applicants begin the application process with ERAS regardless of their matching program at the beginning of their fourth and final year in medical school. At this point, students choose specific residency programs to apply for that often specify both specialty and hospital system, sometimes even subtracks (e.g., Internal Medicine Residency Categorical Program at Mass General or San Francisco General Primary Care Track).
Sources: en.wikipedia.org
It is a seven-amino-acid peptide, Thr-Lys-Pro-Arg-Pro-Gly-Pro, produced by chemical synthesis rather than extracted from biological tissue. Its design is based on tuftsin, a natural immunomodulatory tetrapeptide. The C-terminal Pro-Gly-Pro segment is a common stabilising motif in short regulatory peptides.
The core four residues correspond to tuftsin, which occurs naturally as part of immunoglobulin G. The full seven-residue sequence, however, is not a known endogenous peptide. It is a laboratory-designed analogue intended to combine tuftsin-like activity with greater resistance to breakdown.
No single receptor has been confirmed as the primary target. Reports describe involvement of the GABAergic system, interference with enkephalin degradation, and shifts in neurotrophic factor expression. Because these observations come from different models and assays, they have not yet been integrated into one accepted mechanism.
Reverse-phase HPLC is the usual method and gives a percentage purity value. Mass spectrometry then confirms the molecular mass. Together they provide a basic identity and purity profile for a lot.